Go to step 6.Ĭonfigure manually without using information stored in keychainĪ. When prompted to install the software, click Next. When prompted, disconnect the USB cable from your computer and your machine. The settings will remain unchanged if you click Cancel.įor Advanced Users: If you want to manually enter the IP address settings on your machine, click Change IP Address and enter the necessary IP address settings for your network.į. If you receive a security prompt for NETserver.app, click Allow. The settings will be sent to the machine. On the Wireless Network Settings Confirmation screen, click Next. You will need to follow the steps to manually configure the network settings without using information stored in keychain.Į. If this is not the network to which you want to connect, choose No and then click Next. Choose Yes if this is the network to which you want to connect, and then click Next.
Once your network is found, the results will be displayed.ĭ. The installer will try to detect your wireless network. When you receive the Installation confirmation message stating that the wireless settings will be automatically detected, place a check next to Checked and confirmed and then click Next.Ĭ. You may also try restarting your computer and your Brother machine.ī. Make sure the cable is not in your Brother machine's ethernet port. If the installation freezes at this point, verify that the USB cable is securely connected to your Brother machine and computer.
This step may take a few minutes for the USB driver to be installed. Make sure your Brother machine is powered on. When prompted, temporarily connect the USB cable (not included) directly to your computer and your Brother machine. Configure using information stored in keychainĪ.
0 kommentar(er)
